I'm looking at the docs on docker mode and running the script. Is this script run after the venv and code dir are setup, or immediately after the container starts but before the environment for running the experiment is setup?
Yes, but is it run after the requirements are installed and the code is mounted? The docs sayIf we look at the console output in the web UI, the third entry should start with Executing: ['docker', 'run', '-t', '--gpus...', and towards the end of the entry, where the downloaded packages are mentioned, we can see the additional shell-script apt-get install -y bindfs.which seems like that would be the case but I'm not sure what the 1st or 2nd entries are and so want to confirm.
so there's no way to do that when running in pip or conda mode?
Hi JumpyPig73 , extra_docker_shell_script is only used in docker mode 🙂
The Agent pulls the Task, and then reproduces it, and now it will execute the extra_docker_shell_script that was put in the configuration file.Does this imply the former? Env is fully setup, then script is run, then experiment is started by calling the executable?
If you run in docker mode you can specify startup shell script
